Latest activity
-
Olds 307 and 403 replied to the thread My 1970 Oldsmobile Cutlass S.Better again, high 12's with the choke on. Idle was low 13 to 14. Part throttle was 13's to a low 15. I turned in the mixture screws... -
Olds 307 and 403 replied to the thread My 1970 Oldsmobile Cutlass S.So I got my wideband O2 sensor installed. This Qjet is very rich, it was idling like ***** now I know why. Idle was around 11 about 2.5...
-
4455 [email protected] posted the thread Oil Gets Dirty fast in Engine / Transmission / Driveability.Here's my build: '81 Pontiac Firebird, 468 cu in Olds, 224/[email protected]/2", .507" lift 110 LSA Hydraulic Roller cam, 1.6 Roller Rockers...
-
4455 [email protected] replied to the thread 403 Olds Block, Pistons, etc.what is a 450? where are you located. I'm in los angeles near the airport.[, LAX, 90045
-
CClassic OM replied to the thread 403 Olds Block, Pistons, etc.I have a 450 just saying. But let me know if you would like to trade
-
Olds 307 and 403 replied to the thread My 1970 Oldsmobile Cutlass S.So the springs weren't bad to change, thanks to the one inch diameter solid steel bar about 5 feet long with a flat end. I kept it from...
-
-
Olds 307 and 403 replied to the thread Oldsmobile 374 stroker build.So I have got my shop mostly free of water and have the dehumidifier going. I should be able start assembly of the 358 in the next few...
-
-
Olds 307 and 403 replied to the thread 307 dip stick tube part #.Roy, a screw threaded in with vise grips and tapping up on it, always remove the broken dipstick for me. Without removing the pan and...
-
Roy Ale replied to the thread 307 dip stick tube part #.looking over some info on dip stick tubes , sounds like the best way to get a dip stick tube out is to remove the oil pan and tap... -
Rocketman269V replied to the thread Cadillac brougham 87.Welcome to the site! What kind of help are you looking for, parts or advice? -
TNeed help with emmissions please
-
I need a dip stick tube for a 1982 - 307 engine. I had my car into a shop to have all the frost plugs changed. There is still...
-
Olds 307 and 403 replied to the thread Oldsmobile 374 stroker build.So I painted the non Stainless 3/8" flange on the full length Chinese Stainless full length headers with VHT high temp aluminum paint to...
-
-
Olds 307 and 403 replied to the thread My 1970 Oldsmobile Cutlass S.So the stainless headers just arrived. The only issue is a dent, others have had similar. The welds and finish look great for $300...
-
-
Olds 307 and 403 replied to the thread My 1970 Oldsmobile Cutlass S.I ordered a new headlight surround, two headlight bezels, in pieces and the wheel well trim as mine needs replacement when new paint...
