Can I sand blast my piston rods and piston. I know I cans sandblast the pin hole or the pin. Can I also sandblast my crank caps? Does the rough surface affect the bearing installation?
thanks
Can anyone tell me the stock length of a 1966 442 400E block push rod length? This the the engine with the .921 lifters. I have a length of 9.4375 on the ones that I have removed.
i have searched the web for hours.
How long should stock push rods be?
If the piston is marked with .030 does that mean it is bored .030?
How can I tell if a cam is good or not? Worn or not?
I have just purchased a used olds 442 400 engine. I assume the specs of the pistons are .030 as the top of the piston has that engraved in it. How do I find out the stock length of push rods for. the 66 olds 400 engine?
How will I know if the main bearings and rod bearings have up sized to a...
Hello
i decided to join to get some help and knowledge from real olds fans.
i have three olds motors. The current completely reconditioned motor is a 330 which sit in my 1066 442 which is 90% body off to date. I have finally found the right engine after 9 years of looking.
i was afraid I would...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.